This content originally appeared on HackerNoon and was authored by Nicolas Frankel
This post will be short, but I hope it proves to be useful.
\ My home is getting more and more connected, and the number of my automations grows each passing month. Recently, I equipped my roller shutters with connected Somfy engines so they could roll down automatically when it’s too hot in summer. Spoiler: given the current heatwave, it’s a boon!
\ I naively created the following automation configuration:
- id: '1742926520608'
alias: Close all shutters
description: Close all shutters if it's already hot in the morning
triggers:
- trigger: time #1
at: 07:00:00
conditions:
- condition: numeric_state
entity_id: sensor.saint_julien_en_genevois_temperature
above: 23 #2
actions:
- action: cover.close_cover #3
metadata: {}
data: {}
target:
entity_id: cover.all_shutters #4
mode: single
- If at 7 AM local time
- The temperature where I live is higher than 23°C
- Close
- All shutters
\
Note the entity ID cover.all_shutters: it’s not an out-of-the-box entity. I explicitly created a group for it:
cover:
- platform: group
name: "All shutters"
entities:
- cover.left_shutter
- cover.middle_shutter
- cover.right_shutter
- cover.bedroom_shutter
- cover.office_shutter
I copied the same approach to switch all the lights off when I leave home. I soon realized there were flaws in this approach.
\ While the probability of adding more shutters is pretty low, I’ll likely add more smart lights in the future. Every time I add one, I’ll need to put it in the group. Also, I added lights in waves; I ID’d the lights in French at first, but later switched to English. As I renamed them all in English to be coherent, I had to update my dashboard to adapt to the new IDs.
\
Home Assistant already has everything to cater for the above, Areas. You can–and you probably should-assign every device to an Area. Once done, you can replace the target part of the automation with a list of area_id instead of entity_id.
- id: '1742926520608'
alias: Close all shutters
description: Close all shutters if it's already hot in the morning
triggers:
- trigger: time
at: 07:00:00
conditions:
- condition: numeric_state
entity_id: sensor.saint_julien_en_genevois_temperature
above: 23
actions:
- action: cover.close_cover
metadata: {}
data: {}
target:
area_id: #1
- office
- bedroom
- living_room
mode: single
Now, Home Assistant closes all shutters that are in any of these areas.
\
Areas tend to be much more stable than individual devices. How often do you add a new area to your home? Granted, an area doesn’t explicitly map to a room, but I think that’s a better approach than my original one. Home Assistant will now manage every new device of the same type added to the area, e.g., if you motorize a new shutter or add a new light.
\ There’s one drawback to this approach. UI Tiles accept only a single entity ID. Thus, if you want to use the GUI, you must create a group as I did in my first approach.
\ In this post, I showed how you could replace the explicit grouping of devices by areas. It’s the same idea of loose coupling we have in software, but applied to Home Assistant configuration.
\ To go further:
Originally published at A Java Geek on July 13th, 2025
This content originally appeared on HackerNoon and was authored by Nicolas Frankel